Jeep Door Holder Installation Instructions

Thank you for purchasing a F&F STEEL Jeep Door Holder!  We hope you’ll love it!

 

Installation Instructions:

To install the 3/8“ lag screws, you will need the following tools and materials:

  • A drill
  • A drill bit slightly smaller than the diameter of the screw shank (around 15/64")
  • Level
  • A 9/16” socket wrench 
  • 3/8” lag screws
  • 3/8” washers

Here are the steps to install the 3/8” lag screw:

  1. Determine the location where you want to install your F&F STEEL Jeep Door Holder.
  2. Using a level, ensure that the door holder is level vertically. 
    1. Skipping this step may cause issues when installing your Jeep Doors for storage.
  3. Mark the holes with a pencil or marker where you intend to drill.
    1. Ensure you’re drilling into a stud or other secure holding material.
  4. Using the drill and the 15/64" drill bit, drill pilot holes at the spots marked in step 3. Make sure the hole is straight and goes at least 1-1/2" deep.
  5. Hold up the F&F STEEL Jeep Door Holder and start the 3/8” lag screws, with the 3/8” washer, by hand.
  6. Use the 9/16” socket wrench to turn the screw clockwise. Keep turning the screw until it is fully tightened and secure.

Note: It's important to make sure that the pilot hole is slightly smaller than the screw diameter to ensure a tight fit and prevent the screw from stripping the hole. It's also important to make sure that the screw is installed straight and fully tightened to ensure a secure hold.